BC Biomedical IPA-2000S Manuel d'utilisateur télécharger pdf (Page 58)

2-26

PRIMING

PRIMINGPRIMING

PRIMING

Close Valve and Remove Priming Syringe

Once the 50 mL of Distilled Water is injected into the Module,

close the Valve and remove the syringe.

STEP 5

Press Start Key to Set the Prime

As prompted, use to set the prime and go to the test

selection screen.

STEP 6

CHANNEL 1 IDLE

SELECT TEST TYPE

FLOW TEST

Before selecting test, prepare and attach the DUT following

steps 7 through 9 to insure proper connection.

NOTE:

CFor Maximum Accuracy, all air

must be cleared from the unit. This

best done by a high flow rate which

is easily obtained with firm pressure

on the priming syringe.

STEP 4

Open Valve, Forcefully Inject Distilled Water

Open Valve and forcefully inject 50 mL of Distilled Water. If

more than one syringe full of water is required, close valve

between fills. Take care not to inject air into the unit.

1 2 ... 53 54 55 56 57 58 59 60 61 62 63 ... 161 162

Pas de commentaire

BC Biomedical IPA-2000S Manuel d'utilisateur Page 58